2. click on custom and also on the right side of the page you will see some settings with that you can create the weight and width, also what i did was change the
using the rectangle tool make a square.
<------ rectangle tool
by using the transform tool on the right side of the illustrator page u can scale the size of your square.
once you have the size you wanted click on the corners of your square/key chain and click and hold on the circle and move it around till its at a good curve for your keychain so it doesn't poke you.
click on the outline on our square and click on the the tool bar that looks like image down below and click on the second box to the right and make it red.
rights click on the the rectangle tool and press the eclipse tool .make a circle and put in the top left corner of your key chain.
once you have all these done for your key chain its time to start customizing it. you can click on the T to make a text.
once you have your text down click on it. in the tool bar in the bottom right corner click on create outline
make sure to image trace everything you load in, click on default.
once you have your desgin done upload to your drive and bring the USB to your laser printer. plug your usb into you computer that is connected to your laser printer and open up illustrator again. when you open up illustrator click on your design and open it, once your design is open and in front of you go up to file and hit print look down to were it says set up ad click on that then hit preferences.
in the top left you will see materials pick your materials. next at the bottom you will see your material thickness measure that and put it into the program. next put your speed and power up top. hit ok press print then print again and after you have done that open up your ucp program from there you will upload your file . over to the right of the screen you will see the control pannel.
hit the like cupside down looking button you will use tht to figure out where the cutting will happen.
if your cutting borders are off the material use the button next to it and move your design and once you a ready hit the big play button.
now just wait till your laser successfully cut out your piece .